When the supplier works, the dust bearing gas is evenly distributed to the filter bag room of each unit through the air volume regulating valve of the inlet pipe of the dust removal system. Due to the actual expansion of the air flow section or the action of the deflector, part of the large particles in the air flow will fall into the ash hopper due to inertia. Small particles of dust through screening, inertia, adhesion, diffusion and static electricity are blocked by the action to stay in the outside of the filter bag, the purification of the sense of trust gas into the bag, collected into the clean gas chamber, discharged through the exhaust pipe. central dust removal system supplier The compressed air is injected into the filter bag in the filter bag chamber of the unit through the upper nozzle of the spray pipe through the air bag through the pulse valve. After the end of the injection, the lifting valve is opened, and the filter bag recovers the filtering state. Similarly, the filter bag room of the remaining units is controlled by the program controller to carry out the above injection cycle in order to achieve the purpose of ash cleaning. In the later stage, the dust that falls off in the ash hopper due to the expansion of the filter bag and the reverse acceleration is sent away by the ash conveying device.

central dust removal system supplier Installation process:

First, when installing the central dust removal system supplier, it is necessary to pay attention to the damage of the box and accessories, and the aperture of the tank top needs to be less than the dust collector.

Second, the top of the tank should be welded on the top of the ash storage tank. Then switch on the induced draft fan.

Third, then switch on the air compressor, and also need a soft connection. This is the way to connect to the dust collector reservoir.

Iv. central dust removal system supplier shall conduct inspection before installation. All the parts are in good condition. If they are found to be damaged or deformed, they shall be repaired in time.

Fifth, the dust collector needs to be sealed inside the box, and no arbitrary air leakage can occur.

6, the filter cartridge installation in the dust collector needs to be vertically fixed in it, and to be compact.

central dust removal system supplier can be equipped with shot blasting machine, sand machine, grinder, sand screening machine, sand mixing machine and other equipment with good dust concentration dust removal, practice has proved stable operation, low noise, dust removal, easy operation and maintenance. Pulse jet single machine dust collector is mainly composed of outer shell, high pressure fan, filter bag, dust collection drawer, abdominal chamber, air inlet pipe, air duct, circuit device, etc. The emergence of the central dust removal system supplier has brought great help to our environmental cause, because it can not only remove dust, but also prevent air pollution and prevent substances from harming our health. Therefore, the central dust removal system supplier is a kind of equipment that is helpful to our health.

central dust removal system supplier https://www.kaisenfilter.com/Central-Dust-Collector